MILAPEAK 2 Pack 3/4” 3:1 Adhesive-Lined Heat Shrink Tubing, Black & Red 4 Feet
– Best for appliance/auto electric wire cable harness wrapping, solder joint protection etc.
– High Quality
– Long service life
– High Strength Toughness
– Corrosion resistance
– Good electrical insulation
– High temperature resistance
How to use it?
1. Please measure diameter of wire which is equal to the size of tube after shrinked, as it is 3:1 heat shrink ratio, and will shrink up to 1/3 of original diameter,
2. Wrap the cable wire with the tube, then use a heat gun heating it until the wire was wrapped tightly.
3. Don’t touch the tube until it becomes cool.
Make sure temperature of your heat gun is up to 212℉(Fahrenheit), then glue inside will soften and seal the connection.
– Color: Black and Red
– Diameter: 3/4 inch
– Length: 4 feet
– Material: Polyolefin
– Heat shrink ratio: 3:1
– Operating Temperature:-55°C to + 125°C
– Minimum Shrinkage Temp: 70°C
– Full Shrinkage Temp: 110°C maximum
– Tensile strength: 10.4Mpa
– Dielectric strength: 15 kV / mm
– Flammability: Flame Retardant
– 4 ft 3/4″ Black Dual-Wall 3:1 Adhesive Lined Heat Shrink Tubing
– 4 ft 3/4″ Red Dual-Wall 3:1 Adhesive Lined Heat Shrink Tubing